Waterworks Ludlow Low Profile Three Hole Deck Mounted Lavatory Faucet with Metal Lever Handles - Manual

PRODUCT SUPPORT 800.927.2120 8am - 6pm EST
LUDLOW
Three Hole Deck Mounted Lavatory Faucet
INSTALLATION GUIDELINES
Page 1 of 3 10.30.2013
These guidelines have been prepared for the professional contractor to aid in the installation of:
LUDLOW DECK MOUNTED LAVATORY FAUCET WITH METAL CROSS HANDLES (STYLE#
LDLS01) & METAL LEVER HANDLES (STYLE# LDLS10)
All dimensions are based on original specification and are subject to change and variation.
Please consult your Design Associate for current specifications.
SEE SERVICE PART DOCUMENT FOR PART ORDERING, AVAILABLE ON WATERWORKS.COM
Metal Cross Handles
Style No. LDLS01
Metal Lever Handles
Style No. LDLS10
SPECIFICATIONS:
Drain Depth: 9/16" MIN - 2-3/16" MAX
Drain Hole Diameter: 1-1/2"
Drain Style: USA Push Touch
Fitting Hole Diameter: 1-3/8"
Handle Spread: 8" MIN - 12" MAX
Inlet Connection Size: 1/2"
Inlet Connection Type: Male with Supply Nut
Maximum Deck Thickness: 1-15/16"
Minimum Deck Thickness: 1/4"
Maximum Water Pressure: 80 psi
Minimum Water Pressure: 20 psi
Recommended Water Pressure: 45 psi
Restricted Maximum Flow Rate: 1.5 gpm
IMPORTANT:
¾ NOTE: The screws on the escutcheons are aesthetic
and do not serve any mechanical purposes, and
should not be removed.
¾ To ensure this product is installed properly, you
must read and follow these guidelines.
¾ The owner/user of this product must keep this
information for future reference.
¾ Be sure your installation conforms to federal state,
and local codes. In the State of Massachusetts, all
installations must comply with the rules and
regulations set forth within 248 CMR.
¾ This product must be installed by a professional
licensed contractor.
¾ Inspect this product to ensure you have all the parts
required for proper installation.
¾ Use only a strap wrench or protected/smooth-jaw
wrench on any finished surface.
¾ The use of certain plumber's putty may stain stone
or tile surfaces.
SPOUT INSTALLATION:
¾ See Figure 1. for Steps 1-3.
1. Remove the TEE, TEE RUBBER WASHER, NUT &
SPOUT METAL WASHER from the bottom of the
spout.
2. Insert the SPOUT and SPOUT SHANK into the
ESCUTCHEON and through the hole on the
mounting surface making sure the SPOUT O-RING is
underneath the ESCUTCHEON.
3. Re-install SPOUT METAL WASHER and NUT (in that
order). Hand-tighten the TEE making sure the TEE
RUBBER WASHER is in the outlet.
Figure 1
SPOUT
ESCUTCHEON
SPOUT METAL WASHER
NUT
TEE RUBBER WASHER
TEE
AERATOR
SPOUT
SHANK
SPOUT
O-RING