Waterworks Regulator Gooseneck Single Spout Kitchen Faucet, Metal Wheel Handle and Spray - Manual (Page 4)

PRODUCT SUPPORT 800.927.2120 8am - 6pm EST
REGULATOR
Gooseneck Single Spout Kitchen Faucet Installation Guidelines
Page 4 of 4
Rev - 01
10.9.2014
These guidelines have been prepared for the professional contractor to aid in the installation of:
REGULATOR GOOSENECK SINGLE SPOUT KITCHEN FAUCET WITH METAL WHEEL HANDLE AND SPRAY
(STYLE No. RGKM20, RG20KM UK)
All dimensions are based on original specification and are subject to change and variation.
Please consult your Design Associate for current specifications.
15. Connect the hot & cold HOSES to the corresponding
SUPPLY KITS (not supplied).
NOTE: The HOSES are marked with colored ZIP TIES
to identify their function.
Red for incoming hot supply
water and blue for incoming cold supply water.
16. Remove the AERATOR from the SPOUT using the
TOOL provided then open the hot and cold supplies
and carefully turn the WHEEL HANDLE to flush out any
debris in the supply lines before operating the SPRAY.
17. Inspect all connections for leaks.
18. Operate the LEVER HANDLE and ensure that a range
of temperatures exists.
19. With the SPOUT on, operate the SPRAY to ensure
that water is being diverted properly. No water should
flow out of the SPOUT while the SPRAY is being
operated.
20. Shut the water off and re-install the AERATOR.
SERVICING THE SPOUT:
1. To remove the SPOUT, unthread the NUT to expose
the SET SCREWS on the front and back of the SPOUT
VALVE BODY. See FIGURE – 09.
2. Loosen the SET SCREWS and pull the SPOUT up to
remove as shown in FIGURE – 09.
FIGURE - 09
SERVICING THE SHUT-OFF CARTRIDGE:
1. To access the SHUT-OFF CARTRIDGE, unthread the
SCREW then remove the HEX COLLAR, METAL
WASHER, WHEEL HANDLE, and HANDLE STEM as
shown in FIGURE – 10.
SET SCREW
"FRONT AND BACK"
NUT
SET SCREW
"FRONT AND BACK"
NUT
2. Unthread the GLAND COVER to expose the
SHUT-OFF CARTRIDGE as shown in FIGURE – 10.
FIGURE - 10
SERVICING THE MIXING CARTRIDGE:
1. To access the MIXING CARTRIDGE, unthread the
SCREW then remove the HEX COLLAR, LEVER
HANDLE and TRIM PLATE as shown in FIGURE – 11.
2. Unthread the RETAINING COLLAR to expose the
MIXING CARTRIDGE as shown in FIGURE – 11.
FIGURE – 11
 If further assistance is required, please contact
Product Support at 1-800-927-2120 Ext 2 Monday
through Friday, 8am - 6pm EST.
 See the service part document for parts ordering,
available on WATERWORKS.COM.
* Putty contains oil and can cause permanent
discoloration on certain materials such as marble,
granite and any porous surface.
SHUT-OFF
CARTRIDGE
GLAND
COVER
HANDLE
STEM
WHEEL
HANDLE
METAL
WASHER
HEX
COLLAR
SCREW
SHUT-OFF
CARTRIDGE
GLAND
COVER
HANDLE
STEM
WHEEL
HANDLE
METAL
WASHER
HEX
COLLAR
SCREW
MIXING
CARTRIDGE
RETAINING
COLLAR
LEVER
HANDLE
TRIM PLATE
HEX
COLLAR
SCREW
MIXING
CARTRIDGE
RETAINING
COLLAR
LEVER
HANDLE
TRIM PLATE
HEX
COLLAR
SCREW