Before requesting service, Iilï – Panasonic NVVX22EG User Manual
Page 148
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

iilï
ENGLiSH
Before Requesting Service
Power Source
Symptom
Cause
Action
■■l'iPâgê;;-'
!.' ;
V •
■ : • ■
I
;
-'I
'
1':
• ! .................
Movie Camera does not turn on. i
>■
When using Battery as power source:
Attached Battery is discharged
Attach fully charged Battery.
Movie Camera has turned off
'
automatically.
r Recording was paused for more than
6 minutes.
Turn in [POWER] Switch to turn Movie
Camera off and then turn it out again to
turn Movie Camera on.
Movie Camera quickly turns off.
i
►
Condensation has formed inside Movie
.-Camera.;:’;
h' ¡ii’h";::
Wait until condensation has cleared up
(approximately 2-3 hours).
Cassette
Remaining Tape Time Indication is i
not correct.
r Tape length of inserted cassette is not
correctly selected.
Select correct tape length.
X-ray inspection was done at airport. i
Did it affect cassettes?
r No, It has no adverse influence.
' '
When playing back stored cassette, i
picture IS distorted.
'
► Cassette may have been magnetized by
other equipment.
Unfortunately, there is no remedy.
Store cassettes correctly.
126
^ Cassette was stored in unsuitable place.
11 '
Unfortunately, there is no remedy.
Store cassettes correctly.
126
Recording
N¡3 picture appears m Finder. ■
• LCD Monitor IS open (Except when
recording with LCD Monitor facing
forward).
Securely close LCD Monitor.
Picture on' LCD Monitor is not clear. • • Picture quality is not properfy adjusted.
Adjust picture quality.
38
Movie Camera is turned on but no •
picture appears in Finder.
■ Power Save Functions have become
activated.
Hold Movie Camera again in horizontal
position. Or set [APS] on Main Menu
[MAIN MENU] to [OFF].
Recording:doesnotistartwhen:: . •
pressing Recording Start/Stop
Button.
' Tab of inserted cassette is broxen out.
Insert cassette with intact tab.
Or cover hole with two layers of
adhesive tape.
Date/Time or Title Indication is not i
displayed on LCD Monitor or in
Finder.
■ Incorrect operation of [DATE/TITLE] and/or
[MENU] Button.
Press [MENU] Button and set the
desired Date/Time/Title Indication, and
then press [DATE/TITLE] Button so that
Date/Time/Title Indication appears.
; : 4 4 i :
DateiTimp Indicatibp is not displayed •
on LCD Monitor or in Finder.
- BuilNn Lithium Battery'is'discharged. ‘
Charge built-in Lithium Battery.
148