Welch Allyn SmartLinkTM Wireless - User Manual - Manual (Page 19)

3
15
Options and setup
eSync Sending Station
Multiple Welch Allyn PIC50 devices will be sending 12-lead data to the monitoring station.
Each PIC50 must have an associated PDA handheld computer for transmission.
Figure 1: PIC50 eSync Transmission Setup
As seen in “Figure 1: PIC50 eSync Transmission Setup” , an eSync installation requires a
Welch Allyn PIC50 to be connected to an approved handheld computer using the serial
cable supplied by the handheld manufacturer. See
“Minimum eSync PDA requirements
for transmitting 12-leads” on page 4 for approved handheld computers and auxiliaries.
Note that some handheld computers/auxiliaries may require a RS232 male-to-male
gender changer to connect to the PIC50. As explained in section 3, the eSync application
is loaded onto the handheld computer during the installation process.
PIC50
Version X3 or greater
Optional gender changer
(male to male)
PDA RS-232 cable
PDA with cellular
connection
eSync
Program