Welch Allyn SmartLinkTM Wireless - User Manual - Manual (Page 14)

10 Installation and upgrade Welch Allyn SmartLink Wireless
SmartLink Wireless Gateway installation
To install SmartLink Wireless Gateway
1. If upgrading or re-installing the SmartLink Wireless Gateway after the initial
installation, it may be necessary to stop the service if it is running. This must be done
prior to proceeding with the gateway installation. Administrative privileges are
required to proceed. Access the services tool using “Start|Administrative
Tools|Services.” Alternatively, “Start|Run…” can be used by executing the command
“services.msc /s.” Find and select “SmartLink Gateway Service” and stop it, then
proceed with the installation.When the installation begins, the setup procedure will
uninstall any previous version of the service. The main setup screen will display a
message “Removing previous version of SmartLink Wireless Gateway Service.”
2. SmartLink Wireless Gateway Service Login Configuration. Use this dialog to specify
the account under which the service will automatically login on startup of the system,
or anytime the service is restarted.
a. Select Login Account. First select the login account from one of the four options:
• Local Service
• Network Service
• Local System
• This Account
The first three choices are Windows built-in system accounts will not require a
password. If the fourth option is selected, a valid account name and password
must be entered as specified below.
b. Account Name. Specify the account name in the format “{domain name}\{account
name}.” Even if specifying a account on the local computer, the domain name
must be specified. In this case, either use the computer name or simply “ . “(e.g.
“.\myaccount”).
c. Password. Enter and confirm the password for the specified account.
3. After completing all the entries, press OK.
4. Service Installation. The main setup screen should display the message “Installing
SmartLink Wireless Gateway Service with automatic startup.” When this is
completed, the installation will proceed automatically to the next step.
5. SmartLink Wireless Gateway Service Configuration. Use this dialog to configure the
SmartLink Wireless Gateway.
6. Enter data for each of the appropriate fields as follows:
a. Gateway Service IP Address. Enter the IP address that will be used for listening
for connections from eSync on the PDAs. This will be the address that will receive
Note If this is the initial installation of SmartLink Wireless Gateway, skip ahead to
Step 2 .
Note The installation program will not verify the account information. If it is entered
improperly, the installation of the service may fail, or the service may not be able
to start. If this occurs, you can either restart the installation, or manually configure
the username an password of the service from the Service control panel or
Computer Management application.