Welch Allyn SmartLinkTM Wireless - User Manual - Manual (Page 10)

6 Installation and upgrade Welch Allyn SmartLink Wireless
To use USB:
Click on the check box for Allow USB connection with this desktop
computer.
4. Status Icon: Select Show status icon in the TaskBar.
Click OK.
To connect the handheld to the PC
1. Connect the handheld using the cable or docking cradle to the USB port, or to the
COM port (selected in the previous step while configuring the ActiveSync application)
of your PC. This should automatically connect the PC to the handheld via the
ActiveSync application. (Once connected, the round-shaped ActiveSync icon both on
the PC and the handheld should turn green in color).
2. If the connection is not made automatically:
a. Double click the ActiveSync icon.
b. On the ActiveSync application, select File. Select Get Connected.
c. If still not connected to the PDA, reset the PDA following the manufacturer’s
instructions for a reset. Typically this is done by inserting the stylus in a small hole
at the bottom of the PDA. After the reset, repeat
Step 1 above.
3. Depending on the version of ActiveSync, a “New Partnership” dialog screen may
appear. If so, select Guest Partnership and press Next.
Note A cable or docking cradle is needed to connect the handheld to the PC. The cable
or docking cradle must be supplied by the manufacturer of the handheld or its
approved vendor.