Reviewing patient data, Displaying stored patient data, Printing patient data – Welch Allyn 300 Series Vital Signs Monitor - User Manual User Manual
Page 59: 5 - reviewing patient data
5
55
Reviewing patient data
You can review stored patient data either by viewing it on the monitor or by printing it.
Displaying stored patient data
1.
Press
to display the most recent stored set of patient vital-signs data.
•
The monitor interrupts the dynamic display of any current vital-sign
measurement.
•
The message READING appears in the message window, with a data-set
sequence number and the time of the displayed reading. (During a patient data
review, if MAP is enabled, this display alternates every two seconds with the
MAP display.)
2.
Press
or
to cycle through the stored measurement data sets. (The monitor
stores 99 measurement cycles.)
3.
To return to normal operation, press any button other than
or
. If you press a
function button (such as
), the monitor returns to normal operation with that
function (
) activated.
Printing patient data
The printer provides a way to view and save patient vital-signs data. It can be configured
to print all stored data as a single batch or to print a continuing stream of data as the data
is recorded in memory. (See
“Selecting stream or batch printing”
To start and stop printing
•
If the monitor is not printing, press
to start printing.
•
If the monitor is printing, press
to stop printing. (If the monitor is set to Stream
printing, the printer prints a footer before stopping.)
Note
The information in this section pertains only to monitors configured with the
optional thermal printer.
Note
The print button is not enabled during an NIBP cycle or during a nonrecoverable
equipment alert.