Welch Allyn 300 Series Vital Signs Monitor - User Manual - Manual (Page 29)

Directions for Use Chapter 2 Setup 25
Changing temperature type and measurement units
Default setting: F (Fahrenheit predictive).
To change the temperature type and the temperature measurement units:
1. With the monitor on, press repeatedly until TEMP MODE appears in the display
window. One or two green LEDs to the right of the temperature window illuminate to
indicate the selected temperature type.
2. Press or as needed to cycle to the desired display:
F (Fahrenheit Predictive)
F M (Fahrenheit Monitored)
C (Celsius Predictive)
C M (Celsius Monitored)
3. To select the displayed units and return to normal operation, either do nothing for 10
seconds or press any button other than
or . If you press a function button (such
as ), the monitor returns to normal operation with that function ( ) activated.
For information on temperature measurements, see “Patient monitoring” on page 29.
SYS
DIA
SpO 2 %
/min
mmHg
ºC ºC
M
TEMP MODE
SYS
DIA
SpO 2 %
/min
mmHg
ºF ºF
0
98
.
6
20:30:16
79
119