Welch Allyn 300 Series Vital Signs Monitor - User Manual - Manual (Page 27)

Directions for Use Chapter 2 Setup 23
MAP measurement enable and disable
Default setting: MAP ENABLED for neonate; MAP DISABLED for adult and pediatric.
1. Depress for 3 seconds. SET HOUR XX appears in the message window.
2. Press repeatedly until MAP ENABLED or MAP DISABLED appears in the
display window.
3. Press or to enable or disable MAP measurement.
4. To select the displayed state and return to normal operation, either do nothing for 10
seconds or press any button other than
or . If you press a function button (such
as ), the monitor returns to normal operation with that function ( ) activated.
For information about MAP measurements, see “Patient monitoring” on page 29.
Note If you change the MAP enabled/disabled setting, refer to “How changing the
patient type affects MAP defaults” on page 34.
SYS
DIA
SpO 2 %
/min
ºF ºF
mmHg
MAP DISABLED
SYS
DIA
SpO 2 %
/min
ºF ºF
mmHg
MAP ENABLED