Vinten Radamec FHR-35 - Manual (Page 4)

2
Installation and Configuration Guide
FHR-35 Pan and Tilt Head Robotic
Safety and Warnings
Follow all warnings and instructions marked on the
product and in this manual. Safety warnings are
included in this manual. These safety instructions must
be followed to avoid possible personal injury and
damage to the product.
WARNING! Do not install this product onto a bracket,
support or other equipment that is not designed to
support the weight of the product and its payload. All
supports must comply with local government
regulations.
WARNING! The fitting of non-approved parts and
accessories, or the carrying out of non-approved
alterations or servicing can be dangerous and could
affect the safety of the product. It may also invalidate
the terms and conditions of the product warranty.
WARNING! This product must be connected to a
power supply of the same voltage (V) and current (A)
as indicated on the product and described in the
specification section of this manual. To reduce the
risk of electric shock, do not remove the covers. No
user-servicable parts inside. Refer all servicing to
qualified service personnel.
WARNING! This product is Class 1 equipment. For
safe operation this equipment must be connected to
a power supply that has a protective earth connection
(US: ground).
CAUTION! This product is designed for robotic use only
and is operated remotely. Do not attempt to manually
operate this product.
CAUTION! Slots and openings are intended for
ventilation purposes to ensure reliable operation of
the product and protect it from overheating. Do not
block or cover any slots and openings.
CAUTION! Do not use solvent or oil-based cleaners,
abrasives or wire brushes to remove accumulations
of dirt as these damage the protective surfaces. To
clean mechanical surfaces, use only detergent-based
cleaners.
WARNING! Risk of personal injury. All personnel must
be fully trained and adhere to correct manual handling
techniques. It is the responsibility of the individual and
the local organisation to enforce safe working practices
at all times.
WARNING! Risk of personal injury or injury to others. All
personnel must be fully trained and adhere to local
health and safety laws and guidelines. It is the
responsibility of the local organisation to enforce safe
working practices at all times.
For your personal safety, read these instructions. Do not
operate the product if you do not understand how to use it
safely. Save these instructions for future reference. Electrical Connection
Basic Electrical Insulation (Class 1 equipment)
Ventilation and Overheating
Cleaning and Maintenance
WARNING! The IEC connector is the primary
disconnect device and must be accessible both during
and after installation of the product.
WARNING! Inspect the AC cable regularly for signs of
wear or damage. If the AC cable is damaged, the
product must be returned to Vinten Radamec for repair.