Vinten Radamec FHR-35 - Manual (Page 29)

Troubleshooting
Fault Check Action
Power supplied, but the camera cradle is
not moving. Check that the tilt lock is disengaged. See Locking/unlocking the Camera
Cradle
Head not operating. Check that the power switch is ON. See Powering up
Ensure that the power and Ethernet
cables are connected and secure. See Electrical Connections
Check mains power supply to head. Check that power is being supplied from
the pedestal, height drive or studio
supply.
Camera and payload moving too far on
the pan and/or tilt axis. Check the setting of the hard and soft
limits. See Setting the Pan and Tilt Hard
Limit Stops
and
Setting Pan and Tilt Soft Limits
Intermittent or no communications Check Ethernet cable.
Check the Ethernet cable is CAT5E FTP. If possible, try using another Ethernet
cable.
27
FHR-35 Pan and Tilt Head Robotic
Installation and Configuration Guide