Vinten Radamec FHR-35 - Manual (Page 32)

30
FHR-35 Pan and Tilt Head Robotic
General Notices
Installation and Configuration Guide
Compliance
FHR-35
V4096-0001
FCC Declaration of Conformity
This product complies with Part 15 of the FCC Rules,
Operation is subject to the following two conditions:
(1) This product may not cause harmful interference.
(2) This product must accept any interference received,
including interference that may cause undesired
operations.
FCC Notice
This product complies with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may
cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one
or more of the following measures:
Ÿ Reorient or relocate the receiving antenna
Ÿ Increase separation between the equipment and receiver
Ÿ Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected
Ÿ Consult the dealer or an experienced radio/television
technician for assistance.
FCC Warning
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the equipment.
General Purpose Connector
The General Purpose Connector can be used to connect a
Camera Control Unit (CCU) or for switching and powering other
camera accessories. The pin outs of the connector are given in
the following table.
CAUTION: Total power drawn from the 12V pins of this
connector must NOT exceed 30W.
Pin No. Description Pin No. Description
1 Not connected 14 Not connected
2 Aux GND 15 CCU TXD422
3 Aux +12V 16 CCU TXD232
4 Aux +12V 17 Not connected
5 Not connected 18 GP I/O 1
6 CCU RXD422 19 GND
7 CCU RXD232 20 Aux GND
8 GP I/O 3 21 Aux +12V
9 GP I/O 0 22 Not connected
10 GND 23 CCU TXD422
11 Aux GND 24 CCU RXD422
12 Aux GND 25 Not connected
13 Aux +12V 26 GP I/O 2