U engineering symbol (esym) – Casio SERIES FX-9860G User Manual
Page 85
20070201
*
1
The { ° ’ ” } menu operation is available only
when there is a calculation result on the
display.
*
2
The {ENG} and {ENG} menu operations are
available only when there is a calculation
result on the display.
u Angle Units, Coordinate Conversion, Sexagesimal Operations (ANGL)
[OPTN]-[ANGL]
• {°}/{r}/{g} ... {degrees}/{radians}/{grads} for a specifi c input value
• {° ’ ”} ... {specifi es degrees (hours), minutes, seconds when inputting a degrees/minutes/
seconds value}
• { ° ’ ”} ... {converts decimal value to degrees/minutes/seconds value}*
1
• {Pol(}/{Rec(} ... {rectangular-to-polar}/{polar-to-rectangular} coordinate conversion
• {
'DMS} ... {converts decimal value to sexagesimal value}
u Engineering Symbol (ESYM)
[OPTN]-[ESYM]
• {m}/{
}/{n}/{p}/{f} ... {milli (10
–3
)}/{micro (10
–6
)}/{nano (10
–9
)}/{pico (10
–12
)}/{femto (10
–15
)}
• {k}/{M}/{G}/{T}/{P}/{E} ... {kilo (10
3
)}/{mega (10
6
)}/{giga (10
9
)}/{tera (10
12
)}/{peta (10
15
)}/
{exa (10
18
)}
• {ENG}/{ENG} ... shifts the decimal place of the displayed value three digits to the
{left}/{right} and {decreases}/{increases} the exponent by three.*
2
When you are using engineering notation, the engineering symbol is also changed
accordingly.
2-4-2
Function Calculations
# ENG/ENG switching is disabled for the following
types of calculation results.
- Result of matrix calculation input in the Math
input mode
- Result of list calculation input in the Math input
mode