Rice Lake Counterpart Configurable Counting Indicator - User Manual - Version 1.0 - Manual (Page 60)

54 Counterpart User Manual
Command Description Values
SC.GRADS#n Graduations 1–100000
SC.ZTRKBND#n Zero track band 0, 0–100
SC.ZRANGE#n Zero range 1.900000, 0–100
SC.MOTBAND#n Motion band 1, 0–100
SC.SSTIME#n Standstill time 1–65535
SC.OVRLOAD#n Overload FS+2%, FS+1D, FS+9D, FS
SC.DIGFLTR1#n
SC.DIGFLTR2#n
SC.DIGFLTR3#n Digital filtering 1, 2, 4, 8, 16, 32, 64, 128, 256
SC.DFSENS#n Digital filter cutout sensitivity 2OUT, 4OUT, 8OUT, 16OUT, 32OUT, 64OUT, 128OUT
SC.DFTHRH#n Digital filter cutout threshold NONE, 2D, 5D, 10D, 20D, 50D, 100D, 200D, 250D
SC.THRESH#n Zero threshold 0–9999999
SC.SMPRAT#n Sample rate 30HZ, 60HZ, 120HZ, 240HZ, 480HZ, 960HZ
SC.PWRUPMD#n Power up mode GO, DELAY
SC.TAREFN#n Tare function BOTH, NOTARE, PBTARE, KEYED
SC.PRI.DECPNT#n Primary units decimal position 8.888888, 88.88888, 888.8888, 8888.888, 88888.88,
888888.8, 8888888, 8888880, 8888800
SC.PRI.DSPDIV#n Primary units display divisions 1D, 2D, 5D
SC.PRI.UNITS#n Primary units lb, kg, g, oz, OFF
SC.ACCUM#n Accumulator enable ON, OFF
SC.WZERO#n Zero calibration —
SC.WVAL#n Test weight value test_weight_value
SC.WSPAN#n Span calibration —
SC.WLIN.F1–
SC.WLIN.F5#n Actual raw count value for linearization
points 1–5 0–16777215
SC.WLIN.V1
SC.WLIN.V5#n Test weight value for linearization points
1–5 0.000001–9999999
SC.WLIN.C1–
SC.WLIN.C5#n Calibrate linearization points 1–5 —
SC.LC.CD#n Deadload coefficient —
SC.LC.CW#n Span coefficient —
SC.LC.CZ#n Temporary zero —
SC.REZERO#n Rezero —
SC.SEC#n Secondary units lb, kg, g, oz, OFF
SC.TER#n Tertiary units lb, kg, g, oz, OFF
Table 6-6. SCALES Serial Commands
Command Description Values
EDP.BAUD#p Port baud rate 1200, 2400, 4800, 9600, 19200, 28800, 38400, 57600, 115200
EDP.BITS#p Port data bits/parity 8NONE, 7EVEN, 7ODD
EDP.STOPBITS#p Port stop bits 1, 2
EDP.PRNMSG#p Print message ON, OFF
Table 6-7. SERIAL Port Serial Commands