Rice Lake Counterpart Configurable Counting Indicator - User Manual - Version 1.0 - Manual (Page 10)

4 Counterpart User Manual
Figure 1-1. Numeric Keypad
1.5 Tare Recall
When a stored tare is displayed, Net annunciators will
be turned on. To display a stored tare,
1. Set up a soft key (see Softkey Setup below).
2. Press the DISPLAY TARE softkey .

The tare value will be displayed. If there is no
tare in the system, pressing the
TARE key will
have no effect. The Gross/Net annunciators
are not lit and a value is displayed in weight
display area.
1.6 Annunciator Symbols
1.7 Softkey Setup
Softkeys offer additional ways to access features
associated with the
Counterpart . To access the
softkey setup parameter, go to Menu -> Setup -> Config
-> Feature -> Softkeys .
Select information for each softkey and press TARE
( Enter) key after each entry and then press SaveExit
softkey. To exit back out of the unit, press the MENU
SETUP key twice without saving changes.
Softkeys set for either Display Tare or
Display Accum will automatically time out and revert to
the normal active display after 10 seconds.
1.8 How to use Alpha/Numeric Keypad
Counterpart has the ability to use alpha characters
along with numeric characters. Use the following
steps to change to alpha characters:
1. Select a key labeled with the value desired.
2. Push until the desired value appears, ie: 2
abcABC).
3. Move to the next letter and push until that
value appears.
4. If the next letter is the same key, push the
right arrow (PRINT) to move over to the next
selection.
5. When complete, push TARE(Enter) to save.
Annunciator Description
Zero (Center of Zero)
While in gross weight display mode, this LED
indicates that the current displayed weight
reading is within +/-0.25 display divisions of the
acquired zero, or is within the center of zero
band.
When in the net weight display mode, it
indicates that the current net weight reading is
within +/-0.25 display divisions of the center of
net zero. A display division is the resolution of
the displayed weight value, or the smallest
incremental increase or decrease that can be
displayed or printed.
G/B
Gross weight mode (or Brutto in OIML mode)
N
Net weight display mode.
Table 1-3. Annunciator Symbols
Note