Kontron AT8902M CLI - Manual (Page 270)

Management Commands AT8902M
AT8902M CLI Reference Manual Page 6 - 18
6.6.5.1 no snmp-server community mode
This command deactivates an SNMP community. If the community is disabled, no
SNMP requests using this community are accepted. In this case the SNMP manager
associated with this community cannot manage the switch until the Status is changed
back to Enable.
Format
no snmp-server community mode
Mode Global Config
6.6.6 snmp-server community ro
This command restricts access to switch information. The access mode is read-only
(also called public).
Format
snmp-server community ro
Mode Global Config
6.6.7 snmp-server community rw
This command restricts access to switch information. The access mode is read/write
(also called private).
Format
snmp-server community rw
Mode Global Config
6.6.8 snmp-server enable traps violation
This command enables the sending of new violation traps designating when a packet
with a disallowed MAC address is received on a locked port.
NOTE: For other port security commands, see 2.6 “Protected Ports Com-
mands” on page 2 - 30.
Default disabled
Format
snmp-server enable traps violation
Mode Interface Config
6.6.8.1 no snmp-server enable traps violation
This command disables the sending of new violation traps.
Format
no snmp-server enable traps violation
Mode Interface Config
6.6.9 snmp-server enable traps
This command enables the Authentication Flag.
Default enabled
Format
snmp-server enable traps
Mode Global Config