Kontron AT8902M CLI - Manual (Page 211)

AT8902M Utility Commands
Page 5 - 11 AT8902M CLI Reference Manual
Rx FCS Errors - The total number of packets received that
had a length (excluding framing bits, but including FCS
octets) of between 64 and 1518 octets, inclusive, but had
a bad Frame Check Sequence (FCS) with an integral number
of octets
Overruns - The total number of frames discarded as this
port was overloaded with incoming packets, and could not
keep up with the inflow.
Received Packets Not Forwarded
Total - A count of valid frames received which were dis-
carded (in other words, filtered) by the forwarding pro-
cess.
Local Traffic Frames - The total number of frames dropped
in the forwarding process because the destination address
was located off of this port.
802.3x Pause Frames Received - A count of MAC Control
frames received on this interface with an opcode indicat-
ing the PAUSE operation. This counter does not increment
when the interface is operating in half-duplex mode.
Unacceptable Frame Type - The number of frames discarded
from this port due to being an unacceptable frame type.
Multicast Tree Viable Discards - The number of frames dis-
carded when a lookup in the multicast tree for a VLAN
occurs while that tree is being modified.
Reserved Address Discards - The number of frames discarded
that are destined to an IEEE 802.1 reserved address and
are not supported by the system.
Broadcast Storm Recovery - The number of frames discarded
that are destined for FF:FF:FF:FF:FF:FF when Broadcast
Storm Recovery is enabled.
CFI Discards - The number of frames discarded that have
CFI bit set and the addresses in RIF are in non-canonical
format.
Upstream Threshold - The number of frames discarded due to
lack of cell descriptors available for that packet's pri-
ority level.
Packets Transmitted Octets
Total Bytes - The total number of octets of data (includ-
ing those in bad packets) received on the network (exclud-
ing framing bits but including FCS octets). This object
can be used as a reasonable estimate of Ethernet utiliza-
tion. If greater precision is desired, the etherStatsPkts
and etherStatsOctets objects should be sampled before and
after a common interval. -----
Packets Transmitted 64 Octets - The total number of pack-
ets (including bad packets) received that were 64 octets
in length (excluding framing bits but including FCS
octets).
Packets Transmitted 65-127 Octets - The total number of
packets (including bad packets) received that were between
65 and 127 octets in length inclusive (excluding framing
bits but including FCS octets).
Packets Transmitted 128-255 Octets - The total number of
packets (including bad packets) received that were between
128 and 255 octets in length inclusive (excluding framing
bits but including FCS octets).