Kontron AT8902M CLI - Manual (Page 249)

AT8902M Utility Commands
Page 5 - 49 AT8902M CLI Reference Manual
Format
debug igmpsnooping packet
Mode
Privileged EXEC
5.11.8.1 no debug igmpsnooping packet
This command disables tracing of IGMP Snooping packets.
Format
no debug igmpsnooping packet
Mode
Privileged EXEC
5.11.9 debug ping packet
This command enables tracing of ICMP echo requests and responses. The command
traces pings on the network port/ serviceport for switching packages. For routing
packages, pings are traced on the routing ports as well.
Default
disabled
Format
debug ping packet
Mode
Privileged EXEC
A sample output of the trace message is shown below.
<15> JAN 01 00:21:22 192.168.17.29-1 SIM[181040176]: sim_debug.c(128)
20 % Pkt TX - Intf: 1/0/1(1),
SRC_IP:10.50.50.2, DEST_IP:10.50.50.1, Type:ECHO_REQUEST
<15> JAN 01 00:21:22 192.168.17.29-1 SIM[182813968]: sim_debug.c(82) 21
% Pkt RX - Intf: 1/0/1(1), S
RC_IP:10.50.50.1, DEST_IP:10.50.50.2, Type:ECHO_REPLY
The following parameters are displayed in the trace message:
TX/RX
TX refers to a packet transmitted by the device. RX refers
to packets received by the device.
Intf
The interface that the packet came in or went out on. For-
mat used is slot/port (internal interface number).
SRC_IP
The source IP address in the IP header in the packet.
DEST_IP
The destination IP address in the IP header in the packet.
Type
Type determines whether or not the ICMP message is a
REQUEST or a RESPONSE.
5.11.9.1 no debug ping packet
This command disables tracing of ICMP echo requests and responses.
Format
no debug ping packet
Mode
Privileged EXEC
5.11.10 debug rip packet
This command turns on tracing of RIP requests and responses. This command takes no
options. The output is directed to the log file.
Default
disabled
Format
debug rip packet