Kontron AT8902M CLI - Manual (Page 116)

Routing Commands AT8902M
AT8902M CLI Reference Manual Page 3 - 2
3. Routing Commands
This chapter describes the routing commands available in the CLI.
The Routing Commands chapter contains the following sections:
•
3.1 “Address Resolution Protocol (ARP) Commands” on page 3 - 2
• 3.2 “IP Routing Commands” on page 3 - 6
• 3.3 “Router Discovery Protocol Commands” on page 3 - 14
• 3.4 “Virtual LAN Routing Commands” on page 3 - 16
• 3.5 “Virtual Router Redundancy Protocol Commands” on page 3 - 17
• 3.6 “DHCP and BOOTP Relay Commands” on page 3 - 22
• 3.7 “Open Shortest Path First (OSPF) Commands” on page 3 - 24
• 3.8 “Routing Information Protocol (RIP) Commands” on page 3 - 48
The commands in this chapter are in one of three functional groups:
•
Show commands are used to display switch settings, statistics and other informa-
tion.
• Configuration Commands are used to configure features and options of the switch.
For every configuration command there is a show command that will display the
configuration setting.
• Clear commands clear some or all of the settings to factory defaults.
3.1 Address Resolution Protocol (ARP) Commands
This section describes the commands you use to configure ARP and to view ARP
information on the switch. ARP associates IP addresses with MAC addresses and
stores the information as ARP entries in the ARP cache.
3.1.1 arp
This command creates an ARP entry. The value for is the IP address of a
device on a subnet attached to an existing routing interface. is a unicast
MAC address for that device.
The format of the MAC address is 6 two-digit hexadecimal numbers that are separated
by colons, for example 00:06:29:32:81:40.
Format
arp
Mode Global Config
3.1.1.1 no arp
This command deletes an ARP entry. The value for is the IP address of the
interface. The value for is the IP address of a device on a subnet attached
to an existing routing interface. is a unicast MAC address for that device.
Format
no arp
Mode Global Config