Kontron AT8902M CLI - Manual (Page 160)

Routing Commands AT8902M
AT8902M CLI Reference Manual Page 3 - 46
3.7.50 show ip ospf range
This command displays information about the area ranges for the specified <
areaid
>.
The <
areaid
> identifies the OSPF area whose ranges are being displayed.
Format
show ip ospf range <
areaid
>
Modes Privileged EXEC
User EXEC
Area ID The area id of the requested OSPF area.
IP Address An IP address which represents this area range.
Subnet Mask A valid subnet mask for this area range.
Lsdb Type
The type of link advertisement associated with this area range.
Advertisement The status of the advertisement. Advertisement has two possible set-
tings: enabled or disabled.
3.7.51 show ip ospf statistics
This command displays information about recent Shortest Path First (SPF)
calculations. The SPF is the OSPF routing table calculation. The output lists the
number of times the SPF has run for each OSPF area. A table follows this information.
For each of the 15 most recent SPF runs, the table lists how long ago the SPF ran, how
long the SPF took, and the reasons why the SPF was scheduled.
Format
show ip ospf statistics
Modes Privileged EXEC
User EXEC
Delta T How long ago the SPF ran. The time is in the format hh:mm:ss, giving
the hours, minutes, and seconds since the SPF run.
SPF Duration How long the SPF took in milliseconds.
Reason
The reason the SPF was scheduled. Reason codes are as follows:
R - a router LSA has changed
N - a network LSA has changed
SN - a type 3 network summary LSA has changed
SA - a type 4 ASBR summary LSA has changed
X - a type 5 or type 7 external LSA has changed
3.7.52 show ip ospf stub table
This command displays the OSPF stub table. The information below will only be
displayed if OSPF is initialized on the switch.
Format
show ip ospf stub table
Modes Privileged EXEC
User EXEC
Area ID A 32-bit identifier for the created stub area.
Type of Service The type of service associated with the stub metric. FASTPATH only
supports Normal TOS.