Kontron AT8902M CLI - Manual (Page 126)

Routing Commands AT8902M
AT8902M CLI Reference Manual Page 3 - 12
IP Mask The IP mask of the routing interface in 32-bit dotted decimal format.
Netdir Bcast Indicates if IP forwards net-directed broadcasts on this interface. Pos-
sible values are Enable or Disable.
MultiCast Fwd The multicast forwarding administrative mode on the interface. Pos-
sible values are Enable or Disable.
3.2.14 show ip route
This command displays the routing table. The specifies the network for
which the route is to be displayed and displays the best matching best-route for the
address. The specifies the subnet mask for the given . When you
use the
longer-prefixes
keyword, the and pair becomes the
prefix, and the command displays the routes to the addresses that match that prefix.
Use the parameter to specify the protocol that installed the routes. The
value for can be
connected
,
ospf
,
rip
or
static
. Use the
all
parameter
to display all routes including best and non-best routes. If you do not use the
all
parameter, the command only displays the best route.
NOTE: If you use the
connected
keyword for , the
all
option is
not available because there are no best or non-best connected routes.
Format
show ip route [{ [] | {
[longer-prefixes] [] | } [all]
| all}]
Mode Privileged EXEC
User EXEC
Route Codes The key for the routing protocol codes that might appear in the routing
table output.
The
show ip route
command displays the routing tables in the following format:
Code IP-Address/Mask [Preference/Metric] via Next-Hop, Interface
The columns for the routing table display the following information:
Code
The codes for the routing protocols that created the routes.
IP-Address/Mask The IP-Address and mask of the destination network correspond-
ing to this route.
Preference The administrative distance associated with this route. Routes with
low values are preferred over routes with higher values.
Metric The cost associated with this route.
via Next-Hop The outgoing router IP address to use when forwarding traffic to the
next router (if any) in the path toward the destination
Interface The outgoing router interface to use when forwarding traffic to the
next destination
3.2.15 show ip route summary
Use this command to display the routing table summary. Use the optional
all
parameter to show the number of all routes, including best and non-best routes. To
include only the number of best routes, do not use the optional parameter.