Kontron AT8902M CLI - Manual (Page 139)

AT8902M Routing Commands
Page 3 - 25 AT8902M CLI Reference Manual
Mode Router OSPF Config
3.7.3 ip ospf
This command enables OSPF on a router interface.
Default
disabled
Format
ip ospf
Mode Interface Config
3.7.3.1 no ip ospf
This command disables OSPF on a router interface.
Format
no ip ospf
Mode Interface Config
3.7.4 1583compatibility
This command enables OSPF 1583 compatibility.
NOTE: 1583 compatibility mode is enabled by default. If all OSPF routers in
the routing domain are capable of operating according to RFC 2328,
OSPF 1583 compatibility mode should be disabled.
Default enabled
Format
1583compatibility
Mode Router OSPF Config
3.7.4.1 no 1583compatibility
This command disables OSPF 1583 compatibility.
Format
no 1583compatibility
Mode Router OSPF Config
3.7.5 area default-cost (OSPF)
This command configures the default cost for the stub area. You must specify the area
ID and an integer value between 1-16777215.
Format
area default-cost
<1-16777215>
Mode Router OSPF Config
3.7.6 area nssa (OSPF)
This command configures the specified areaid to function as an NSSA.
Format
area nssa
Mode Router OSPF Config
3.7.6.1 no area nssa
This command disables nssa from the specified area id.