19 area virtual-link retransmit-interval (ospf), 20 area virtual-link transmit-delay (ospf), Routing commands at8902m – Kontron AT8902M CLI User Manual
Page 144
Routing Commands
AT8902M
AT8902M CLI Reference Manual
Page 3 - 30
Format
area
virtual-link <
neighbor
> hello-interval <
1-
65535
>
Mode
Router OSPF Config
3.7.18.1
no area virtual-link hello-interval
This command configures the default hello interval for the OSPF virtual interface on
the virtual interface identified by
<
areaid>
and
<
neighbor>
. The
<
neighbor>
parameter is the Router ID of the neighbor.
Format
no area <
areaid
> virtual-link <
neighbor
> hello-interval
Mode
Router OSPF Config
3.7.19
area virtual-link retransmit-interval (OSPF)
This command configures the retransmit interval for the OSPF virtual interface on the
virtual interface identified by
and
. The
parameter
is the Router ID of the neighbor. The range for seconds is 0 to 3600.
Default
5
Format
area <
areaid
> virtual-link <
neighbor
> retransmit-interval
<
seconds
>
Mode
Router OSPF Config
3.7.19.1
no area virtual-link retransmit-interval
This command configures the default retransmit interval for the OSPF virtual interface
on the virtual interface identified by
<
areaid>
and
<
neighbor>
. The
<
neighbor>
parameter is the Router ID of the neighbor.
Format
no area <
areaid
> virtual-link <
neighbor
> retransmit-inter-
val
Mode
Router OSPF Config
3.7.20
area virtual-link transmit-delay (OSPF)
This command configures the transmit delay for the OSPF virtual interface on the
virtual interface identified by
<
areaid>
and
<
neighbor>
. The
<
neighbor>
parameter
is the Router ID of the neighbor. The range for seconds is 0 to 3600 (1 hour).
Default
1
Format
area <
areaid
> virtual-link <
neighbor
> transmit-delay <
sec-
onds
>
Mode
Router OSPF Config
3.7.20.1
no area virtual-link transmit-delay
This command resets the default transmit delay for the OSPF virtual interface to the
default value.
Format
no area <
areaid
> virtual-link <
neighbor
> transmit-delay
Mode
Router OSPF Config