Kontron AT8902M CLI - Manual (Page 177)

AT8902M Quality of Service (QoS) Commands
Page 4 - 9 AT8902M CLI Reference Manual
4.3.2 class-map rename
This command changes the name of a DiffServ class. The
< class-map-name>
is the
name of an existing DiffServ class. The
< new-class-map-name>
parameter is a case-
sensitive alphanumeric string from 1 to 31 characters uniquely identifying the class
(The
‘default’ is reserved and must not be used here).
Default none
Format
class-map rename
Mode Global Config
4.3.3 match ethertype
This command adds to the specified class definition a match condition based on the
value of the ethertype. The
>
value is specified as one of the following
keywords:
appletalk
, arp, ibmsna, ipv4, ipv6, ipx, mplsmcast, mplsucast, netbios,
novell
, pppoe, rarp or as a custom ethertype value in the range of 0x0600-0xFFFF.
NOTE: This command is not available on the Broadcom 5630x platform.
Format
match ethertype { | custom <0x0600-0xFFFF>}
Mode Class-Map Config
4.3.4 match any
This command adds to the specified class definition a match condition whereby all
packets are considered to belong to the class.
Default none
Format
match any
Mode Class-Map Config
4.3.5 match class-map
This command adds to the specified class definition the set of match conditions defined
for another class. The
>
is the name of an existing DiffServ class whose
match conditions are being referenced by the specified class definition. There is no
default value.
Format
match class-map
Mode Class-Map Config
NOTE:
• The parameters
< refclassname>
and
>
can not be the same.
• Only one other class may be referenced by a class.
• Any attempts to delete the
>
class while the class is still referenced
by any fails.
• The combined match criteria of
>
and
>
must be
an allowed combination based on the class type.
• Any subsequent changes to the
>
class match criteria must main-
tain this validity, or the change attempt fails.