Kontron AT8902M CLI - Manual (Page 127)

AT8902M Routing Commands
Page 3 - 13 AT8902M CLI Reference Manual
Format
show ip route summary
[all]
Mode Privileged EXEC
User EXEC
Connected Routes The total number of connected routes in the routing table.
Static Routes Total number of static routes in the routing table.
RIP Routes
Total number of routes installed by RIP protocol.
OSPF Routes Total number of routes installed by OSPF protocol.
Total Routes Total number of routes in the routing table.
3.2.16 show ip route preferences
This command displays detailed information about the route preferences. Route
preferences are used in determining the best route. Lower router preference values are
preferred over higher router preference values. A route with a preference of 255 cannot
be used to forward traffic.
Format
show ip route preferences
Modes Privileged EXEC
User EXEC
Local The local route preference value.
Static The static route preference value.
OSPF Intra The OSPF Intra route preference value.
OSPF Inter The OSPF Inter route preference value.
OSPF Ext T1 The OSPF External Type-1 route preference value.
OSPF Ext T2 The OSPF External Type-2 route preference value.
OSPF NSSA T1 The OSPF NSSA Type-1 route preference value.
OSPF NSSA T2 The OSPF NSSA Type-2 route preference value.
RIP
The RIP route preference value.
NOTE: The configuration of NSSA preferences is not supported in this
release.
3.2.17 show ip stats
This command displays IP statistical information. Refer to RFC 1213 for more
information about the fields that are displayed.
Format
show ip stats
Modes Privileged EXEC
User EXEC