Kontron AT8902M CLI - Manual (Page 110)

Switching Commands AT8902M
AT8902M CLI Reference Manual Page 2 - 74
Format
dos-control sipdip
Mode Global Config
2.18.1.1 no dos-control sipdip
This command disables Source IP Address = Destination IP Address (SIP=DIP) Denial
of Service prevention.
Format
no dos-control sipdip
Mode Global Config
2.18.2 dos-control firstfrag
This command enables Minimum TCP Header Size Denial of Service protection. If the
mode is enabled, Denial of Service prevention is active for this type of attack. If
packets ingress having a TCP Header Size smaller then the configured value, the
packets will be dropped if the mode is enabled.The default is
disabled.
If you enable
dos-control firstfrag, but do not provide a Minimum TCP Header Size, the system sets
that value to
20
.
Default disabled <20>
Format
dos-control firstfrag
[<0-255>]
Mode Global Config
2.18.2.1 no dos-control firstfrag
This command sets Minimum TCP Header Size Denial of Service protection to the
default value of
disabled
.
Format
no dos-control firstfrag
Mode Global Config
2.18.3 dos-control tcpfrag
This command enables TCP Fragment Denial of Service protection. If the mode is
enabled, Denial of Service prevention is active for this type of attack. If packets ingress
having IP Fragment Offset equal to one (1), the packets will be dropped if the mode is
enabled.
Default disabled
Format
dos-control tcpfrag
Mode Global Config
2.18.3.1 no dos-control tcpfrag
This command disabled TCP Fragment Denial of Service protection.
Format
no storm-control broadcast all
Mode Global Config