Kontron AT8902M CLI - Manual (Page 130)

Routing Commands AT8902M
AT8902M CLI Reference Manual Page 3 - 16
3.3.6.1 no ip irdp preference
This command configures the default preferability of the address as a default router
address, relative to other router addresses on the same subnet.
Format
no ip irdp preference
Mode Interface Config
3.3.7 show ip irdp
This command displays the router discovery information for all interfaces, or a
specified interface.
Format
show ip irdp
{<slot/port> | all}
Modes Privileged EXEC
User EXEC
Interface The
>
that matches the rest of the information in the row.
Ad Mode The advertise mode, which indicates whether router discovery is
enabled or disabled on this interface.
Advertise Address The IP address to which the interface sends the advertisement.
Max Int
The maximum advertise interval, which is the maximum time, in sec-
onds, allowed between sending router advertisements from the inter-
face.
Min Int The minimum advertise interval, which is the minimum time, in sec-
onds, allowed between sending router advertisements from the inter-
face.
Hold Time The amount of time, in seconds, that a system should keep the router
advertisement before discarding it.
Preference The preference of the address as a default router address, relative to
other router addresses on the same subnet.
3.4 Virtual LAN Routing Commands
This section describes the commands you use to view and configure VLAN routing
and to view VLAN routing status information.
3.4.1 vlan routing
This command creates routing on a VLAN. The value has a range from 1 to
4094.
Format
vlan routing
Mode VLAN Config
3.4.1.1 no vlan routing
This command deletes routing on a VLAN. The value has a range from 1 to
4094.
Format
no vlan routing