Kontron AT8902M CLI - Manual (Page 267)

AT8902M Management Commands
Page 6 - 15 AT8902M CLI Reference Manual
6.5.4.1 no users snmpv3 authentication
This command sets the authentication protocol to be used for the specified user to
none. The is the user name for which the specified authentication
protocol is used.
Format
no users snmpv3 authentication
Mode Global Config
6.5.5 users snmpv3 encryption
This command specifies the encryption protocol used for the specified user. The valid
encryption protocols are
des
or
none.
If you select
des
, you can specify the required key on the command line. The
encryption key must be 8 to 64 characters long. If you select the
des
protocol but do
not provide a key, the user is prompted for the key. When you use the
des
protocol, the
login password is also used as the snmpv3 encryption password, so it must be a
minimum of eight characters. If you select
none
, you do not need to provide a key.
The value is the login user name associated with the specified encryption.
You must enter the in the same case you used when you added the user.
To see the case of the , enter the
show users
command.
Default no encryption
Format
users snmpv3 encryption
{none | des[key]}
Mode Global Config
6.5.5.1 no users snmpv3 encryption
This command sets the encryption protocol to none. The is the login user
name for which the specified encryption protocol will be used.
Format
no users snmpv3 encryption
Mode Global Config
6.5.6 show users
This command displays the configured user names and their settings. This command is
only available for users with Read/Write privileges. The SNMPv3 fields will only be displayed
if SNMP is available on the system.
Format
show users
Mode Privileged EXEC
User Name The name the user enters to login using the serial port, Telnet or Web.
Access Mode Shows whether the user is able to change parameters on the switch
(Read/Write) or is only able to view them (Read Only). As a factory
default, the “admin” user has Read/Write access and the “guest” has
Read Only access. There can only be one Read/Write user and up to
five Read Only users.
SNMPv3 Access Mode The SNMPv3 Access Mode. If the value is set to
ReadWrite,
the SNMPv3 user is able to set and retrieve parameters on the system.
If the value is set to
ReadOnly,
the SNMPv3 user is only able to