ETS-Lindgren HI-4460 Graphical Readout (Archived) - Manual (Page 51)

Operation | 51
Reset
There is a reset button on the HI-4460 circuit board. The reset button can be
accessed through a hole on the upper right side of the battery pack cover on the
back of the unit. The memory is backed up by battery, so all data and setup
information will remain intact.
Setup
The HI-4460 can be setup for a probe even though the probe is not attached.
1. Turn on the HI-4460. NO PROBE will display on the screen.
2. At the Main screen choose the desired probe in the Probe Type field.
3. Select any desired settings for the probe; you may also set up logging.
Attach the probe when you are ready to use it. Everything will be set and ready
for operation.
Archived 4/2/10