ETS-Lindgren HI-4460 Graphical Readout (Archived) - Manual (Page 34)

34 | Menus
• HI LEVEL ENABLE—Selects an upper alarm level. Any reading above this
level will cause a high level alarm. The default settings are: 10.00 (V/m and
kV
2
/m
2
), .0000 (mW/cm
2
).
• LO LEVEL ENABLE— Selects a lower alarm level. Any reading below this
level will cause a low level alarm. The default settings are: 10.00 (V/m and
kV
2
/m
2
), .0000 (mW/cm
2
).
• HI TEMP ENABLE—Selects an upper temperature alarm level. The default
setting is 100 ° F (38 ° C).
• LO TEMP ENABLE—Selects a lower temperature alarm level. The default
setting is 100 ° F (38 ° C).
Archived 4/2/10