ETS-Lindgren HI-4460 Graphical Readout (Archived) - Manual (Page 24)

24 | Screens
At the bottom of most screens is a list of menus that may be selected using the
four Function keys. Alarm messages are also displayed in this area.
The rest of the screen shows the present field reading in large digits, along with
the units of measure currently selected. When there is no probe attached or the
probe is turned off, this area will display NO PROBE.
The following screens replace this large digit reading with information If
auto range is not selected and the reading does not fall within the selected
range, an over or under range condition occurs. When this happens, the area
showing the reading reports an over range or an under range reading. The over
range or under range value is also shown
Press the BACK/ENTER key or SCREEN/SELECT key to scroll through the
monitoring screens, as shown in the following illustrations.
This shows a plot of the composite
reading with the two horizontal bars
representing the upper and lower
limits of the range selected
This shows a bar graph of each of
the axes being monitored as well as
their values. This screen is not
available if axis enable in the
MAIN menu is set to COMP
(composite).
Archived 4/2/10