ETS-Lindgren HI-4460 Graphical Readout (Archived) - Manual (Page 46)

46 | Logging
• START HEADER—Displays the two newest log files in memory. The
newest log file is selected by default.
• END HEADER—Displays the two newest log files in memory. The newest
log file is selected by default. More than one log file may be sent at once. By
default, only the newest log file in memory will be sent. If a block of the files
are to be uploaded, they must be selected using the up and down
MODE key, the BACK/ENTER key, or the SCREEN/SELECT key. Files
must be selected by the block, so all log files between the start header file
and end header file selected will be uploaded. To define a block of files,
select the end file from the block desired (the file with the oldest date
desired). Return to the START HEADER and select the beginning file from
the block desired (the file with the newest date desired).
• UPLOAD PORT—To send the data selected, choose the method of
transfer: NONE, RS-232, or FIBER. After having the Upload Software
running on your computer, press the BACK/ENTER key and uploading will
begin. If the HI-4460 cannot find the computer you will receive a NO HOST
CONNECTED message and a beep. Wait about 5 seconds and the HI-4460
will return to the main logging menu
NONE: No files sent.
RS-232: Sends the selected files using the RS-232 connector on the
HI-4460.
FIBER: Sends the selected files using the fiber optic connectors on the
HI-4460. An HI-4413P Fiber Optic Modem is required. When
connecting the fiber optic cable, you must switch the polarity of one of
the ends (white-to-yellow and yellow-to-white).
• EXIT— Once uploading has started, you can abort the upload by selecting
the EXIT submenu button.
Archived 4/2/10