Press the button and select a : b – Canon MR-14EX User Manual

Page 61

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Manual Flash Mode

Firing Both Fiash Tubes at a Different Output

After Step 3 on the preceding page, following the steps below to set a

different flash output between flash tube A and B.

Press the

ratio

button and

select A : B .

► Each time you press the button, the

selection will change in the following loop;

A : B

A : B : C <

^(OFF)-

I---------nrsi

A : B

-:iD

oi:-

;fli-C.Fn l\^E +____________- SEU?ET

R^O CH.

• The flash output is displayed on the

lower right of the LCD panel. When

A is displayed, the flash output

displayed is for flash tube A.

Press the < O > or < O > button to

select flash tube A or B, then

press the < + > or <—> button to

set the flash output.

► First select the flash tube, then set the

flash output for that flash tube.

• The remaining steps are the same as

steps 6 and 7 on the preceding page.

Firing Oniy One Fiash Tube

Press the <—> button and set the flash output to -. This disables the

selected flash tube from firing.
• The - setting comes after the 1/64 setting. The flash tube whose flash

output is set to -- will not fire. Also, you cannot set -- for both flash tubes.

o To prevent overheating and deterioration of the flash tubes, observe the

following limits for continuous shooting with flash. If you reach the limit, allow the

MR-14EX to cool for at least 10 min.
(1) At 1/1 or 1/2 output: Max. 15 continuous flash shots.
(2) At 1/4 to 1/8 output: Max. 20 continuous flash shots..
(3) At 1/16,1/32, or i/64 output: Max, 40 continuous flash shots.