Press the button, Focus the subject, Take the picture – Canon MR-14EX User Manual

Page 35: F b - i

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

FEB (Flash Exposure Bracketing)

ETTL

F b - I

■§--C.Fn MODE +

Press the <

sel

set

> button.

►

The MR-14EX’s LCD panel display

will be as shown on the left.

Focus the subject

►

When you press the shutter button

halfway, the FEB setting is displayed

on the viewfinder’s right.

Take the picture.

• Check that the 4 icon is displayed in

the viewfinder before taking the picture.

Repeat steps 4 to 5 to take the

remaining two bracketed shots.

• After all three bracketed shots are

taken, the FEB setting is cancelled
automatically.

FEB cannot be used with any flash exposure compensation set with the camera.

• Before taking the picture, make sure that the MR-14EX’s pilot lamp Is lit or the

icon is displayed In the viewfinder. The □ (single-frame) film advance mode

Is recommended.

• In the *3||, Qy L, , or continuous shooting mode with the EOS-1 D, 1V

or EOS-3, the next bracketed picture will not be taken if the flash is not ready.
While the flash is not ready, you can still take a picture in the normal AE mode
If you release your finger from the shutter button and press It completely.

• With Type-A carheras other than the EOS-1 D, 1V and EOS-3, if the flash is not

ready, you can still take pictures In the normal AE mode.

• When the flash is ready, you can resume taking the bracketed flash shots.

“W“» FE lock and FEB can be used in combination.

• FEB and flash exposure compensation can be set together with the MR-14EX. In this

case, the FEB amount will shift according to the flash exposure compensation amount.

C.Fn-1 can prevent the FEB setting from canceling automatically after the

three bracketed flash shots are taken. (->p.64)

C.Fn-2 can change the sequence of the bracketed flash shots, (^p.64)