Sony MHC-3500 - Manual (Page 60)

mm
^SSSSBBIHPiH
Tape Dubbing
(from deck A to deck B)
Editing the Tape at Normal
Speed
1 Press TAPE of the function selector
on the amplifier.
2 Insert a recorded tape in deck A and a
blank tape in deck B.
3 Set DIRECTION MODE.
4 Locate the beginning of the portion to
be dubbed on deck A, using or
►► and then stop the tape.
5 While keeping REC pressed, press
or
6 Press [> or <] of deck A.
Normal speed dubbing starts.
To stop dubbing
Press □ on both decks.
Note on DIRECTION MODE setting
Position Operation
= Dubbing stops at the end of the tape.
CD
When the tape in one deck comes to
its end, it reverses immediately
regardless of the tape position in the
other deck.
PELAY When the tape in one deck reaches
its end, it stops untii the other tape
comes to its end, and then both
tapes reverse together. (High-speed
dubbing only)
When dubbing starts from the reverse
side in the RELAY mode
At the end of the reverse side, dubbing
stops automatically.
Note
During high-speed dubbing, only □ is operative.
Is it necessary to set DOLBY NR?
Unnecessary for high-speed dubbing. The
tape in deck B is automatically recorded in
the same state as the tape in deck A. For
normal speed dubbing, set DOLBY NR
according to the playback tape.
Is it possible to listen to program
sources other than tape during dubbin
During high-speed dubbing, yes. Any
program source can be selected with the
function selectors.
During normal-speed dubbing, no. The
source changes to that of the function
selector pressed and the tape playback
cannot be dubbed.