Installation verification, Specification – Tomei Powered ARMS M8260 User Manual
Page 31

INSTALLATION VERIFICATION
(1)
Check the E-Brake with the gear in neutral to ensure that it is working
(2)
Double check for any signs of water and oil leaks during idling.
(3)
When the engine is turned off, check the water and oil levels again to be sure that they are
at the right levels. Check the amount of water that has entered the reservoir tank.
(4)
Start the engine and hold it 3,000 RPM and check for any signs of exhaust leaks and/or strange noises.
(5)
Do a test drive and check that the turbo is coming on boost as normal.
・Please use a boost controller to adjust your settings.
・Check your boost meter and boost controller for any abnormal signs.
(6)
Once again check all the parts that were installed and or replaced as well as the water and oil levels
or signs of leaks.
・Do not turn the engine off immediately after hard driving.
・Check engine oil periodically.
SPECIFICATION
NAME
COMPRESSOR
Trim
Inlet Dia.
Outer Dia.
TURBINE
Trim
52.6
55.0
60.0
50.3
72.0
77.1
68.0
76.2
M7655
M8260
31
Exit Dia.
Outer Dia.
POTENTIAL POWER
67.0
580PS
650PS
47.5
58.8
56.0
31