Rally Armor 11-14 Subaru WRX & STI Sedan - Manual (Page 3)

IMF19 Version 1.3 Release Date 10.22.2010
3
• (Figure G) Loosely fit fender cover back on to the vehicle and adjust mounting bracket clearances to cover and side skirt by slightly
tightening or loosening mounting screws. Important: Lower mounting point of bracket is slotted. Align the lower innermost portion
of the bracket by adjusting it inwards, to its fullest extent into the vehicle, prior to final bolting.
• (Figure H) Replace cover and side skirt when adjustment is complete. Fitment is correct when fender cover lip can be slightly
compressed by hand and rests comfortably against protective rubber gaskets behind bracket tabs. Remount two OEM lower side skirt
clips and two remaining OEM fender liner fasteners.
• (Figure I) The front mud flap mounts with the logo facing the rear of the vehicle. Place the mud flap against the corresponding
mounting points on the bracket passing small washers (SmWash) over the flap through the threaded bolts. Install lock nuts (SSLnut) on
the two threaded mounting points. Thread a short screw (1SS) with small washer through the flap into the mounted insert (Ins).
Tighten all points until snug. Do not overtighten.
Rear Mud Flap Installation
• (Figure J) Remove the 5 stock retainers that attach the inner black bumper piece to the bumper cover and vehicle.
• (Figure K) Remove the inner bumper piece from vehicle.
• (Figure L) Slide tabbed or folded end of bracket over outer edge of bumper piece where it meets bumper cover. Align the lower
portion of the bracket at an angle.