Rally Armor 10-14 Subaru Outback - Manual

IMF14/IMF16 Version 1.1 Release Date 3.24.2010
1
To protect your Rally Armor mud flap set, care must be taken during parking and reversing. Check wheel clearance after installation, especially vehicles outfitted
with non‐OEM offset wheels and suspensions. Rally Armor is not responsible for damage or loss of installed flaps.
Each mud flap set contains 4 flaps for all 4 tires of the vehicle.
Recommended tools: Offset, ratcheting or stubby Phillips screwdriver, small flat head screwdriver.
Rally Armor 2010+ Subaru Legacy and Outback mud flap mounting hardware consists of:
Quantity Hardware Item Item ID
14 Polygon Edge Clips PolCl
2 Small Washers SmWash
12 Large Washers Wash
2 Short Screws 1SS
12 Long Screws 1.5SS
2 Rear Mounting Brackets HMF14‐BRKT‐DR;
HMF14‐BRKT‐P
To remove stock fasteners
Cautionary Tip: The hardware is strong and self threading
but over‐tightening the clips is not advised.
Installation Tip: To ease installation and avoid damage to
existing OEM clips during removal, a well lit, climate
controlled installation environment is recommended.
To the installer: Please return these instructions to the
customer after installation. Always test and check wheel
clearance before returning vehicle.
To the customer: Retain these instructions after installation.
They may be necessary for installing other optional parts or
removal of this accessory.