Rally Armor 02 to 07 Subaru Impreza User Manual
Rally Armor For bicycles
Rally Armor Subaru Impreza WRX/STI/RS/2.5i – 2002-2007 Mud flap Mounting Instructions*
*Visit http://www.rallyarmor.com for a better view of the photos and to watch the installation video.
**06-07 wagon owners, visit FAQ section of
a direct fitment-front flaps)
Your mud flap set contains 4 flaps total *2 front (4 mounting points) and *2 rear (3 mounting points)
Your mounting hardware has been checked at our facilities. It consists of:
6 Round Edge Clips for the front…………………….
(Item RoCl)
6 Polygon Edge Clips for the rear……………………
(Item PolCl)
14 Washers ……………………………………………..
(Item FenWash)
8 Short Stainless Steel Screws ………………………
(Item 1SS)
6 Long Stainless Steel Screws ………………………
(Item 2SS)
4 Spacers………………………………………………
(Item 1SP)
2 Plastic Inserts………………………………………..
(Item Ins)
Recommended tools:
Phillips screwdriver *short and/or offset Phillips - Flat head screwdriver - 8mm wrench
Rally Armor recommends professional installation -
Cautionary Note:
The hardware is quite strong and self-threading but overtightening the clips is not
recommended.
FRONT MUD FLAP installation:
Step 1: Remove the clips (1-4) and the two side skirt clips in the front to gain access to the body (fig. A):
I)
Cautionary Note:
Be careful
not
to rip the wheel well plastic. It tears easily. Pull back slowly!
Step 2: Pull the liner back and the side skirt down slightly.
Step 3: Place the round edge clips (Item RoCl) (see fig. B) over hole locations #1, #2 and #3, as shown
above, then place the fender liner back slowly. The liner should cover the clips.
Note:
Liner will touch topmost clips on the interior when placing it back. The plastic liner and clip should
flex slightly. Align with the short screw (Item 1SS) when placing the flap later and it should line up.
A)
B)
C)