Rally Armor 07-13 Mitsubishi Lancer - Manual

Rally Armor Mud flap Mounting Instructions ‐ 2007+ Mitsubishi Lancer
Please read the instructions thoroughly before attempting to mount the mud flaps.
Rally Armor always recommends professional installation.
For higher resolution images and the most up to date instructions please visit http://www.rallyarmor.com.
To protect and extend the life of your rally mud flap set care must be taken during parking and reversing.
Your mud flap set contains 4 flaps total for all four tires of the vehicle Front mud flap (4 mounting holes) – Rear mud flap (3 mounting holes).
Your mounting hardware has been checked.
It consists of:
16 Polygon Edge Clips ……………………………………
(Item PolCl)
16 Washers …………………………………………………... (Item FenWash)
14 Short Stainless Steel Screws ………….………… (Item 1SS)
2 Long Stainless Steel Screws…………………………. (Item 1.5SS)
2 Rear L Brackets……………………………………………. (Item RBRKT1)
2 Spacers………………………………………………..……... (Item .5SP)
Recommended tools: Phillips Screwdriver (short and offset/ratcheting Phillips), Flat head screwdriver, Pliers, Drill & Drill bit set.
Front Mud Flap Installation
le on an even surface. Turn the steering wheel towards the side you are working on to gain access to the wheel
the 4 factory wheel well clips (#1‐#4) that secure the fender liner to the vehicle. To remove the clips, pop the inner tab out of the
point (Figure B). Reinstall liner over
1) Begin by parking the vehic
well area.
2) Remove
assembly first then remove the complete assembly by prying the outer edges of the clip (Figure A).
3) Pull liner away from the body of the vehicle and place 4 polygon clips (PolCl) over each mounting
polygon clips, confirming holes of polygon clips are aligned and visible through the mounting points of the liner (Figure C).
4) Place front mud flap (has 4 holes) against the vehicle mounting points with Rallyarmor logo facing the rear of the car. Place 1 short screw
ind the mud flap hole (the logo side of the flap) that corresponds to mounting point #4. Loosely
(1SS) through a washer (FenWash) then through the mud flap and into mounting points #1 then #2 then #3. Thread mounting points #1‐#3
loosely.
*Do not fully tighten* (Figure D).
5) To mount point #4, place the spacer beh
thread a long screw (1.5SS) through a washer (FenWash), (Figure E).
1
Tip: Rally Armor mud flaps
w ill flex and curve to conform
to the wall of side skirt
equipped models.