beautypg.com

Rally Armor 11-14 Subaru WRX Hatchback User Manual

Rally Armor For bicycles

background image

2008-2014 SUBARU STI & 11-14 WRX HATCHBACK 4 POINTS MUD FLAP INSTALLATION INSTRUCTIONS

For high resolution color images of these instructions, please visit

http://www.rallyarmor.com

To protect your Rally Armor mud flap set, care must be taken during parking and reversing.

Rally Armor is not responsible for damage or loss of installed flaps.

YOUR MOUNTING HARDWARE CONSISTS OF:

RECOMMENDED TOOLS:

Quantity

Hardware Item

Item ID

View

4

Flat U Clips

UClip

8

Inserts

Ins6

8

Screws

1SS

4

Washers

SmWash


Recommended tools:
Offset, ratcheting or stubby Phillips
screwdriver, small flat head screwdriver, drill and bit assortment,
marker.

To the customer:
Retain these instructions after installation. They
may be necessary for installing other optional parts or removal of
this accessory.
To the installer: Please return these instructions to the customer
after installation. Always test and check wheel clearance before
returning vehicle

FRONT MUD FLAPS

- PLEASE READ THE INSTRUCTIONS THOROUGHLY

Figure A. -Remove front tire. Carefully place mud flap against vehicle in a manner where it matches the curvature of the wheel well
and side skirt. Mark the center each of the mounting points with a marker.

Figure B. - Using a 7/32” (5.5mm) bit, drill a hole in each of the mounting points you have marked. Create these holes in the plastic
liner only, do not drill into the sheet metal of the vehicle.

Figure C
. – To ensure a flush fit on the outer edge of the vehicle. Install the OUTER inserts first. Lower insert first, then upper,
pushing the mud flap tightly against the wheel well as the inserts are fastened. Install the two inner inserts afterwards.
Do not apply pressure to the inside of the mud flap in a manner where the outer edge is lifted.

This manual is related to the following products: