Rally Armor 2012+ Fiat 500 - Manual

IMF25
IMF25
Version 1.0 Release Date 3.4.2013
1
2012+ FIAT 500 MUD FLAP INSTALLATION INSTRUCTIONS
PLEASE REVIEW THESE INSTRUCTIONS IN ITS ENTIRETY BEFORE ATTEMPTING INSTALLATION
For high resolution color images of these instructions, please visit http://www.rallyarmor.com
To protect your Rally Armor mud flaps, care must be taken during parking and reversing. Check wheel clearances after installation,
especially on vehicles outfitted with non-OEM offset wheels and suspensions. Adjust accordingly.
Rally Armor is not responsible for damage or loss of installed mud flaps.
Each mud flap set contains 4 flaps, mounting brackets and hardware.
Required tools: Philips screwdriver, 7/16”wrench, 8mm wrench, Small pick, drill, Small pilot drill bit, ¼”(.25”) or 6.35mm drill bit, fine
tip marker, Jack/jack stands.
YOUR MOUNTING HARDWARE CONSISTS OF: INSERTS GUIDE:
Quantity Hardware Item Item ID
2 Front brackets HMF25-BR-FR
2 Rear Brackets HMF25-BR-RE
2 Inserts Ins
2 Wide Base Inserts Ins3
2 Spacers .5Sp
6 Stainless Steel Lock Nuts SSLnut
16 Washers SmWash
4 Polygon Clips PolCl
2 Short Stainless Steel Screws 1SS
2 Long Stainless Steel Screws 2SS
Cautionary Tip: The hardware is strong and self threading but over-tightening the mounting clips is not advised.
Installation Tip: To ease installation and avoid damage to existing OEM clips during removal, a well lit, climate controlled installation environment is
recommended.
To the installer: Please return these instructions to the customer after installation. Always test and check wheel clearances before returning vehicle.
To the customer: Retain these instructions after installation. They may be necessary for installing other optional parts or removal of this accessory.