Rally Armor 11-14 Subaru WRX Hatchback - Manual (Page 4)

IMF15 Version 1.0 Release Date 1.4.2010
4
• (Figure M) Place a supplied clip (PolCl) over the inner mounting point of the bracket.
• (Figure N) Position the rear mud flap with logo facing the rear of the vehicle. Using a short screw (1SS) and a large washer (Wash), bolt
the mud flap to each mounting point. Be sure that the inner mounting point is not interfering with the wheel. If needed, adjust
mounting point by angling the bracket towards the rear of the vehicle and away from the tire. Do not tighten mounting points. Adjust
mud flap first.
• (Figure O) Align outer edge of the flap by incrementally adjusting the lower/upper portion of the flap and walking away from the
vehicle until the flap is perpendicular to even ground. Tighten all mounting screws until snug against washer. Do not over tighten.
• Repeat the front and rear installation process for the other side of the vehicle to complete installation.
All content included on these instructions, such as text, graphics, logos is the copyright of Rally Armor LLC