Rally Armor 11-14 Subaru WRX Hatchback - Manual (Page 3)

IMF15 Version 1.0 Release Date 1.4.2010
3
• (Figure G) Loosely fit fender cover back on to the vehicle and adjust mounting bracket clearances to cover and side skirt by slightly
tightening or loosening mounting screws. Important: Lower mounting point of bracket is slotted. Align the lower innermost portion
of the bracket by adjusting it inwards, to its fullest extent into the vehicle, prior to final bolting.
• (Figure H) Replace cover and side skirt when adjustment is complete. Fitment is correct when fender cover lip can be slightly
compressed by hand and rests comfortably against protective rubber gaskets behind bracket tabs. Remount two OEM lower side skirt
clips and two remaining OEM fender liner fasteners.
• (Figure I) The front mud flap mounts with the logo facing the rear of the vehicle. Place the mud flap against the corresponding
mounting points on the bracket passing small washers (SmWash) over the flap through the threaded bolts. Install lock nuts (SSLnut) on
the two threaded mounting points. Thread a short screw (1SS) with small washer through the flap into the mounted insert (Ins).
Tighten all points until snug. Do not over tighten.
Rear Mud Flap Installation
• (Figure J) Working from the rear of the vehicle, remove stock retainer from under the rear bumper area as shown.
Important: After removal, completely separate inner clip from outer assembly retainer.
• (Figure K) Slide rear metal bracket between bumper and fender liner. Secure bracket by reinstalling outer assembly retainer into
lower oval mounting hole of bumper, though mounting bracket and liner until flush. Important: Install outer assembly without inner
insert as the liner may have shifted and could require realignment. Tap inner portion of insert into place to secure mounting bracket.
• (Figure L) Slide two supplied clips (PolCl ) over stock mounting points in bumper. Important: Lower clip mounts over both bumper
and upper mounting point of metal bracket.