Rally Armor 11-14 Subaru WRX Hatchback - Manual (Page 2)

IMF15 Version 1.0 Release Date 1.4.2010
2
Front Mud Flap Installation
• Begin by parking the vehicle on an even surface. Turn the steering wheel towards the side you are working on to gain access to the
wheel well area.
• (Figure A) Open car door to avoid contact with side skirt. Remove first two push clips under the side skirt.
• (Figure B) Carefully unclip front portion of side skirt by pulling the outer edge away just enough to release two horizontal retainer
clips.
• (Figure C) Remove the plastic fender cover in increments. Pull upper left/right portions of the cover until each plastic retainer clip is
released and work downwards towards side skirt.
• (Figure D) Remove the four OEM fender liner retainer clips. Pull liner away to gain access to inner fender.
• (Figure E) Place two supplied clips (PolCl ) over mounting tabs at an angle (as shown).
• (Figure F) Reinstall fender liner. Place front metal bracket over mounting points with lower portion tucked between side skirt and
liner. Thread flat head screws (15FHSS ) into corresponding two upper mounting points through liner, into clips. Do not fully tighten.
Place insert (Ins), until flush, into the innermost mounting slot of bracket. Remount previously removed upper and inside fender liner
clips . Important: Lower mounting of bracket is slotted. Align the lower portion of bracket at its fullest extent of the slot in towards
the vehicle.