Dell Latitude E4200 (Late 2008) User Manual
Page 55
5.
Replace the five M2 x 3-mm screws on the system board assembly.
6.
Connect the fan and speaker cables to the system board.
7.
Connect the smart card reader and right I/O board cables to the system board.
8.
Lower the right side of the right I/O board in the base assembly, aligning the connectors with the holes in the base assembly.
9.
Place the right I/O board onto the guide pins on the base assembly.
10.
Replace the two M2 x 3-mm screws in the right I/O board in the holes labeled with white arrows.
11.
Gently connect the cable to the right I/O board using the connector release.
12.
Replace the DC power cable (see
Replacing the DC Power Cable
).
13.
Replace the palm rest assembly (
Replacing the Palm Rest Assembly
).
14.
Replace the coin-cell battery (see
Replacing the Coin-Cell Battery
).
15.
Replace the display assembly (see
Replacing the Display Assembly
).
16.
Replace the module with Bluetooth wireless technology (see
Replacing the Card With Bluetooth Wireless Technology
).
17.
Replace the keyboard (see
Replacing the Keyboard
).
18.
Replace the LED cover (see
Replacing the LED Cover
).
19.
Replace the solid state drive (see
Replacing the Solid State Drive and Cable Assembly
).
20.
Replace the memory module (see
Replacing the Memory Module
).
21.
Replace the WLAN and WWAN cards (see
Replacing the WLAN/WiMax Card
and
Replacing a WWAN Card
).
22.
Replace the service panel (see
Replacing the Service Panel
).
23.
Follow the procedures in
After Working on Your Computer
.
24.
Flash update the BIOS (see
Flashing the BIOS
for more information).
25.
Enter the system setup program to update the BIOS on the new system board with the computer Service Tag. For information on the system setup
program, see the Dell™ Technology Guide on your computer or at support.dell.com.
Back to Contents Page
NOTE:
If you use a BIOS update program disc to flash the BIOS, press
for one time only. Otherwise, you must enter the system setup program to change the default boot order.