beautypg.com

Radio switch board, Removing the radio switch board, Replacing the radio switch board – Dell Latitude E4200 (Late 2008) User Manual

Page 43

background image

Back to Contents Page

 

Radio Switch Board

Dell™ Latitude™ E4200 Service Manual

  

Removing the Radio Switch Board

  

Replacing the Radio Switch Board


The radio switch board (RSB) acts as a hub for multiple antennae/cable connections. A component of this hub is a specially designed cable that acts as a relay
from the RSB to the wireless local area network (WLAN) card.

 

 

Removing the Radio Switch Board

 

1.

Follow the procedures in

Before Working on Your Computer

.


 

2.

Remove the service panel (see

Removing the Service Panel

).


 

3.

Remove the WLAN/WiMax card (see

Removing the WLAN/WiMax Card

).


 

4.

Disconnect the cables from the radio switch board.

Disconnect the two Latitude ON™ card cables (gray and black), and the two antenna cables (gray and black).

 

5.

Disconnect the power cable from the radio switch board.

 

6.

Remove the two M2 x 3-mm screws.

 

7.

Lift the front edge of the radio switch board up and towards the front of the computer to remove it from the base assembly.

 

Replacing the Radio Switch Board

 

1.

If your computer does not have a WWAN card installed, make sure that the WWAN cables are routed in the cable holders in the base assembly.

 

2.

Lower the back edge of the radio switch board down and towards the back of the computer into the base assembly. Make sure that no other cables
other than the WWAN cables are under the radio switch board when lowering it into place.

 

3.

Replace the two M2 x 3-mm screws.

 

4.

Connect the cables to the radio switch board.

Connect the antenna cables to the connectors on the back left side of the board, connecting the gray cable to the connector marked with a "G" and the
black cable to the connector marked with a "B".

CAUTION:

Before working inside your computer, read the safety information that shipped with your computer. For additional safety best

practices information, see the Regulatory Compliance Homepage on www.dell.com at: www.dell.com/regulatory_compliance.

NOTE:

The radio switch board is optional and may not be present on your computer.

1

Latitude ON card cables (2)

2

screws (2)

3

antenna cables (2)

4

radio switch board

5

base assembly

6

power cable connector