Dell Latitude E4200 (Late 2008) - Manual (Page 10)

Back to Contents Page
Card With Bluetooth
®
Wireless Technology
Dell™ Latitude™ E4200 Service Manual
Removing the Card With Bluetooth Wireless Technology
Replacing the Card With Bluetooth Wireless Technology
Removing the Card With Bluetooth Wireless Technology
1. Follow the procedures in Before Working on Your Computer .
2. Remove the LED cover (see Removing the LED Cover ).
3. Remove the keyboard (see Removing the Keyboard ).
4. Disconnect the cable from the system board by gently pulling up on the release latch.
5. Lift up on the module to remove it from the base assembly.
6. Turn the module upside down.
7. Remove the M2 x 3-mm screw from the card.
8. Pull up on the card to disconnect it from the connector on the module.
Replacing the Card With Bluetooth Wireless Technology
1. Connect the card to the card connector on the module.
2. Replace the M2 x 3-mm screw on the card.
3. Turn the module topside up, and press the module into the base assembly.
4. Connect the cable to the system board using the release latch.
5. Replace the keyboard (see Replacing the Keyboard ).
CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage on www.dell.com at: www.dell.com/regulatory_compliance.
1 release latch 2 cable
3 base assembly 4 module
5 card 6 card connector
7 screw