beautypg.com

Figure 6 – Dell PowerVault 745N User Manual

Page 58

background image

l

 

Connect the remote access controller cable to the bottom of the remote access controller. See

Figure 6

-9

.

6.

 

Insert the expansion card firmly into the expansion-card connector on the riser board until the card is fully seated, being careful not to remove the riser

board from the system board.

 

7.

 

Replace the expansion-card retainer. See

Figure 6

-7

.

8.

 

Connect any remaining internal or external cable(s) to the expansion card.

9.

 

If installing a remote access controller, connect the cable to the remote access controller connector on the system board. See

Figure 6

-9

.

10.

 

Replace the daughter card if it was removed. See "

Installing a Daughter Card

."

11.

 

Close the system. See "

Closing the System

" in "Troubleshooting Your System."

Figure 6-7. Installing and Removing Expansion Cards

 

Figure 6-8. Installing and Removing a CERC SATA RAID Controller

 

Figure 6-9. Installing and Removing a Remote Access Controller

 

NOTE:

Ensure that the expansion-card bracket is also inserted into the securing slot on the chassis's back panel.