Dell PowerVault 745N - Manual (Page 29)

Address mark not found
Faulty hard-drive subsystem;
defective system board.
Ensure that the hard drive cables are properly connected. See " Troubleshooting Hard
Drives " in "Troubleshooting Your System" for the appropriate drive(s) installed. If the
problem persists, the system board may be defective. See " Troubleshooting the System
Board ."
Alert! Cover was
previously removed!
The chassis has been opened. Information only.
Alert! CPU fan was not
detected.
Alert! Memory fan was not
detected.
Alert! PCI fan was not
detected.
Specified fan is faulty or the
fan assembly is not installed
correctly.
Ensure that the fan assembly is properly installed. See " Troubleshooting a Fan " in
"Troubleshooting Your System."
Alert! DIMM(s) n are
unsupported.
Unsupported or faulty memory
module(s).
Ensure that the memory modules are properly populated. See " Memory Module Installation
Guidelines " in "Installing System Components." If the problem persist, see " Troubleshooting
System Memory " in "Troubleshooting Your System."
Alert! Mismatched DIMMs
are detected in Bank n.
Potential for decreased
performance!
The memory module
installation guidelines have not
been properly followed.
Ensure that the memory modules are properly populated. See " Memory Module Installation
Guidelines " in "Installing System Components."
Alert! Previous CPU fan
failure.
Alert! Previous Memory fan
failure.
Alert! Previous PCI fan
failure.
Specified fan failed before last
system startup.
Information only.
Alert! Previous voltage
failure.
The power supply failed before
last system startup.
Information only.
Alert! Processor thermal
probe failure detected.
The processor fan is faulty, or
the fan assembly is improperly
installed.
Ensure that the fan assembly is properly installed. See " Troubleshooting a Fan " in
"Troubleshooting Your System."
Alert! Previous processor
thermal event was
detected.
The processor fan failed before
the last system startup.
Information only.
Auxiliary device failure
Loose or improperly connected
mouse or keyboard cable;
faulty mouse or keyboard.
Replace the mouse. If the problem persists, replace the keyboard.
BIOS Update Attempt
Failed!
Remote BIOS update attempt
failed.
Retry the BIOS update. If the problem persists, see " Getting Help ."
Caution! NVRAM_CLR jumper
is installed on system
board. Please run SETUP
Incorrect configuration settings
in System Setup program;
NVRAM_CLR jumper is installed;
faulty system battery.
Check the System Setup configuration settings. See "Using the System Setup Program" in
your User's Guide. Remove the NVRAM_CLR jumper. See Figure A -2 for jumper location.
Data error
Faulty hard drive. Ensure that the hard drive cables are properly connected. See " Troubleshooting Hard
Drives " in "Troubleshooting Your System" for the appropriate drive(s) installed in your
system.
Decreasing available
memory
Faulty or improperly installed
memory modules.
Ensure that all memory modules are properly installed. See " Troubleshooting System
Memory " in "Troubleshooting Your System."
Faulty or improperly installed
remote access controller (RAC)
Ensure that the RAC's cable is properly connected. Ensure that the RAC is properly
installed. See " Troubleshooting Expansion Cards " in "Troubleshooting Your System."